|
Product Details:
|
| Size: | 1.75 /3.0 Mm | Colors: | 12 Colors |
|---|---|---|---|
| The Tolerance Roundness: | ±0.02mm | Print Temperature: | 200℃ -240℃ |
| Floor Temperature: | 100℃ - 1200℃ | Filament Net Weight: | 1kg/Spool |
| Length: | 335m/132m | Gross Weight: | 1.3kg/Spool |
| Highlight: | 3d printing pla filament,pla 3d printer material |
||
12 Colors PETG 3d Printer Filament For 3D Printing
PETG 3D printer filaments information:
PETG is a very tough material with good thermal resistance. Its use is universal but especially suitable for mechanical parts and both indoor and outdoor use. PETG has almost no warping, so printing large objects isn’t a problem. We use PETG to print parts for our printers!
The G in the acronym PETG stands for Glycol which is added during the manufacturing process. Glycol modifies the properties of PET, so that it’s easier to print, less brittle and clearer when printing with semi-transparent variants. PETG has a low thermal expansion, so even when printing big objects, and without an enclosure, it rarely lifts from the bed and warps. In addition to that, PETG is ductile. It has a healthy amount of flex which can prevent parts from breaking under pressure.
Unlike PLA or ABS, PETG tends to ooze a bit and may leave strings of plastic on your print. You can fight this with increasing retraction and playing with hotend temperature, but if you use our filament presets in Slic3r or Prusa Control, we already did that for you and the amount of stringing is minimal. If you witness a tiny bit of stringing anyway, you can get rid of it by quickly blasting your finished prints with a heat gun.
Parameter
| Filament Diameter | 1.75/3.00mm |
| Tolerance | ±0.02mm |
| Print Temp | 200—240℃ |
| Bed Temp | 100-120℃ |
| Bed Setting | Masking tap or temperature resistant heat tape |
| Applicable Models | FDM—3D Printer |
Spool Size:
Quality control:
1. All of our 3D printer filaments are 100% virgin material,never use recycled material or regrind material,and all had achieved the latest certificate.
2.Before the mass production,our engineer always do the test to make sure that each batch of new raw materials must be printed by 3D printer.
3.The Laser diameter runs automatically to control the diameter of the filaments and keeps it in a right range of 1.75/3.0mm,and our engineer will adjust it immediately when it alarms to indicate of wrong size,and this unqualified filament will be cut off and never use it.
4.To keep the filaments dry,each roll of filament is packed in a vacuumed polybag with a desiccant inside of it.
Contact Person: Carr
Tel: +8613533633723
Fax: 86--0769-82329070
